Installation / Operation Instruction Manual

BLP SERIES Install, Operation, and Maintenance Manual
SECTION 3: OPERATION AND CONTROLS
Rev-1 Bradford White • 200 Lafayette St. • Middleville, MI 49333 Page 31 of 83
BrutePlate Manual Phone: [phone] • Website: www.BradfordWhite.com 02/26/2020
In Levels 3 or Config the Page button will scroll through list headers (no auto-repeat). If
the Page button is pressed within a list, the display reverts to the top of the list. The top
of the list shows only the list header with no initial parameters.
 Page (held for >3 seconds): The Goto parameter is selected directly. This operation
can be performed from any display. If the Page is held for >3 seconds at power-up, the
Quick Start Mode is selected following the entry of a passcode.
 Page+Raise: Scroll back the list headers (with auto-repeat).
 Scroll: Select parameters in turn, returning to the first parameter in the list or to a list
header if Level 3 or Configuration level is selected. If the button is held down the list will
auto-repeat. In levels 1 and 2 this button also scrolls through promoted parameters when
the HOME screen is selected.
 Scroll+Raise: Scroll back through parameters from bottom to top (with auto-repeat).
 Page+Scroll - all variants: Jump directly to the "HOME page." The current operating
level remains unchanged. If the HOME page is already selected, these buttons will
perform the custom function. The default is Alarm Acknowledge.
 Raise+Lower (Run/Hold): If a programmer option is enabled and a program is
configured, a momentary press of these keys toggles between Run and Hold modes.
 Raise+Lower (hold for >3 seconds - Mode): If a programmer option is enabled, and a
configured program is running, holding these buttons will abort the program.
If the HOME page is selected, and the Programmer is not running, holding these buttons
will invoke the 'Mode' display where the Loop Mode parameter will allow selection of
Auto or Manual mode.
 F1 and F2: the functionality of these buttons is set by the Instrument function block. The
default settings are:
• F1: Auto/Man
• F2: Run/Hold
NOTE:
A time-out applies to all displays. If no button presses are detected within a timeout period
(default is 30 min.), the display will revert back to the “HOME screen.”