Installation / Operation Instruction Manual

BLP SERIES Install, Operation, and Maintenance Manual
SECTION 4: MAINTENANCE
Rev-1 Bradford White • 200 Lafayette St. • Middleville, MI 49333 Page 51 of 83
BrutePlate Manual Phone: [phone] • Website: www.BradfordWhite.com 02/26/2020
To disassemble the heat exchanger and access the plate assembly for cleaning or replacement,
refer to Figure 4-2 and to the instructions that follow. Parts in Figure 4-2 are labeled according
to the nomenclature used in the disassembly instructions on the next page.
NOTE:
Figure 4-2 is for part identification only and is not meant to accurately portray the plate
assembly.
FIGURE 4-2: Plate and Frame Heat Exchanger Parts
CAUTION!
Only technically qualified persons are allowed to disassemble and perform maintenance on this
heat exchanger.
TIE
BOLTS
(1 of 10)
CLAMPING NUT &
WASHER (1of 20)
SPLASH
GUARD
FOLLOWER
FRAME PLATE
HEAD FRAME
PLATE
SUPPORT
POST
PLATE
ASSEMBLY
PLATE
SUPPORT
BRACES
SUPPORT
POST BOLT
& WASHER
(1 of 2)
FOLLOWER
BRACKET & SCREW