Installation / Operation Instruction Manual

BLP SERIES Install, Operation, and Maintenance Manual
SECTION 3: OPERATION AND CONTROLS
Rev-1 Bradford White • 200 Lafayette St. • Middleville, MI 49333 Page 37 of 83
BrutePlate Manual Phone: [phone] • Website: www.BradfordWhite.com 02/26/2020
3.11.6 Instructions to Change Communication Settings Manually
IP addresses, Subnet Masks and default gateway
CAUTION!
 Do not go to the configuration menu while the controller is operating the water heater.
 Do not power off the controller without completing all the steps in the configuration settings.
Save and go back to the main screen.
 Configurations settings shall be performed only by trained and experienced personnel.
 Proper care must be taken to prevent any changes to other settings in the configurations.
Refer to following steps:
1. Open the front door on the control panel box in order to access the temperature
controller main screen which is shown below:
2. Press and hold page button on the main screen until following screen appears: