User Manual

Page 2

For full instructions regarding the MagnaTech FT,

please reference the MagnaTech FT “Installation and

Operation Manual”, Document #1462. If not available

at or near the MagnaTech FT, it can be downloaded at

www.laars.com

Power

Switch

Touch

Screen

Rating

Plate

Door

Latch

2. Restarting the MagnaTech FT

It may be necessary to restart the MagnaTech FT – for example, after a power interruption. Here are the steps

required to do this:

1 Reset any errors. See Section 12 “Troubleshooting” of the Installation and Operating Manual.

2 Turn up the thermostat to call for heat.

3. In approximately 2 seconds, the blower will operate. Ignition should occur after 35-40 seconds. It may take

as long as 2-1/2 minutes.

4. If ignition does not occur, wait 5 minutes and then repeat steps 1 through 3.

5. If, after three attempts, the unit still does not light, shut down the unit and call your service technician.

1. Shutting down the MagnaTech FT ........ 2

2. Restarting the MagnaTech FT .............. 2

3. Start-Up and Shut-Down Decal. ........... 3

4. In the Event of Power Failure ............... 5

5. General Care ........................................ 5

6. Annual Inspection and Service ............. 5

7. For Service ........................................... 5

8. About Lockouts, Holds and Alerts ........ 5

9. Touchscreen Display ............................ 6

1. Shutting down the MagnaTech FT

It may sometimes be necessary to shut down the

MagnaTech FT. Here are the steps required to do this:

1. Disconnect Power at the main electrical disconnect switch.

2. Shut the main manual gas valve located at the back of the

unit. It has a yellow handle

3. If freezing is anticipated, drain the MagnaTech (also be

sure to protect the piping in the building from freezing.)

The steps listed above may require qualied service personnel.

Example

Brute MagnaTech

Contents