Operator`s manual

MAINTENANCE
POWER DIG BUCKETS
6895
3-8-96
DIGGING POSITIONS
Power dig buckets may be installed in any one of three different
digging positions. By using the different pairs of bucket link mounting
holes, digging characteristics of the backhoe can be changed to suit the
working conditions.
" A " Position A is the power digging position for maximum digging
force in hard ground. This position will give you a 20 percent
increase in digging power over the standard position.
"B" Position B is the truck loading position. It gives greater ease of
spoil removal with a higher dump height than the standard or
power dig position.
"C" Position C is the standard digging position. When the bucket is
mounted in this position, it will have 180° of rotation.
Digging positions are easily changed by removing the bucket link
pivot pin from the bucket. Realign the hole in the bucket link with the cor-
rect holes in the bucket for the desired results. Install the pivot pin and
secure it with the original washers and cotter pins and you're ready to go.
A special bell hole link is required to achieve a true bell hole position.
This part is available from your dealer.
A
B
C
POWER DIG BUCKET
BUCKET LINK MOUNTING HOLES
LL