User guide

5. Advanced operation
5.2.5 Vertical image position
This menu item is only accessible when VGA input is selected.
To adjust the vertical image position
1. Bring up the OSD main menu.
2. Navigate to the VGA menu.
3. Enter the VPostionsubmenu.
The command bar VPositionis highlighted and a small pointer appears to the left of it.
4. Set the vertical image position as desired and confirm.
5.2.6 Amplitude calibratio n
About Amplitude calibration
When Amplitude calibration is activated, the gain and offset of the analog signal will be calibrated to match
the analog input range ADC (required full dynamic signal).
To adjust the amplitude calibration
1. Bring up the OSD main menu.
2. Navigate to the VGA menu.
3. Enter the Amplitude Calibration submenu.
The automatic amplitude calibration is activated.
5.3 Display in formation
About display information
Your display model name, firmware release, monitor on time, backlight on time and signal info are available
in a dedicated submenu of the OSD menu.
To retrieve inf o about your display:
1. Bring up the OSD main menu.
2. Navigate to the Exit menu to make the information visible on the screen.
(451920611082)K5902070 MSMD-1119 & MSMD-1119-TS 05/12/2013
27