User's Manual

smart_mullion_v1.0 Mar05
Smart Mullion Reader
Installation Guide
Smart Standard Mullion
Drilling Template
Regulatory Information
CE Mark
The reader has passed all relevant tests and obtained CE approval.
C Tick
The reader has passed all relevant requirements for application of C Tick.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications to this product not expressly approved in this document could void the user's authority to operate this equipment.
Designed & Manufactured in Australia. Mifare
®
is a registered trademark of Philips Electronics.
Reader Specifications
Reader Output PAC proximity format
Power requirements 12Vdc
Current Consumption (+/- 5%)
Normal 120mA
Activated 140mA
Read range
20 - 60mm (0.8” – 2.4”)(typically)
Operating temperature -10ºC to +55ºC (14ºF to 131ºF)
Relative humidity 90% max, operating non-condensing
Reader dimensions
140mm x 45mm x 32mm (5.51" x 1.77" 0.79")
Status LED’s Green/Red controlled by access controller
Audible tone
Controlled by access controller
Colour Two toned - Silver & Charcoal
IP rating IP 67
Cable distances
0.22mm
2
cable
0.33mm
2
cable
100m max
250m max
PAC INTERNATIONAL LTD
A Stanley Security Solutions Business
1 Park Gate Close, Bredbury, Stockport, SK6 2SZ, England
T: [phone]. F: [phone]
Blick House, Cambridge Commercial Park, 6 Trinity Close,
Paulshof, Sandton, South Africa
T: [phone], F [phone]
Unit 310, Technology Park, 18 On Lai Street, Sha Tin, Hong Kong
T: [phone], F: [phone]
T: [phone], F: [phone]
www.pac.co.uk
[e-mail]
62
45
 20mm (0.79”) hole for wire entry
 2 x 4 mm (0.08” x 0.16”) holes
for mounting screws
 Minimum outer dimension is
140 mm x45 mm (5.51” x 1.77”)
so as not to interfere with any
other components