Instruction manual

Take out printer

• Power off and take out the power cable from electrical outlet.

• Take away platter.

• Screw out 2 bolts (I) at the bottom of the scale.

• Open the printer door.

• Pull out printer, also disconnect the harness in printer PCB and connect ground wire.

• Take out printer, also with sliding feet under it.

Install printer

• Put the sliding base to right position.

• Insert the harness of the printer PCB and connect the ground wire.

• Put the printer to right position and insert to scale carefully.

• Insert the sliding feet under the printer. Screw down 2 bolts for fixing the printer at bottom of scale.

• Close printer door.

• Put on platter.

• Power on scale.