Instruction manual

• Screw down with moment spanner.15kg CAPACITY with 8 NM,

30kg CAPACITY with 10 NM.

• Put the spacer and then screw down 2 screws in it.

• Screw down with moment spanner.15kg CAPACITY with 8 NM,

30kg CAPACITY with 10 NM.

• With X mm ruler to adjust the limit size of back 2 screws. With Y mm ruler to adjust the limit size of front 2

screws inspacer.(capacity:6/15kg X=1.2mmY=0.9mm；capacity:15/30kg X=1.9mmY=1.3mm)

• Insert the loadcell harness to main PCB.

• Install the up cover, print paper cover,up spacer,screws in interface PCB, cover of main PCB at bottom etc.

• Adjust 4 screws in up spacer and let the spacer levelly.

• Put on platter.

• Power on scale.

Hanging type:

bPro-H2

Take out loadcell