Instruction manual

64
【*】
"205 GROUP RPT NO"
【*】
"206 GROUP H RPT NO"
【*】
"207 HOURLY RPT NO"
【*】
"208 SETTLE RPT NO"
【*】
"210 ST/RETN RPT NO"
【*】
"211 VENDOR RPT NO"
【*】
"212 CASHDRAW RPT NO"
【*】
"213 WEEKLY RPT NO"
【*】
"214 MONTHLY RPT NO"
【*】
"215 YEARLY RPT NO"
【*】
"NOT PRINT"
(press key [↓] to select print or not print report）
【*】
18 CLEAR REPORTS
【*】
"DELETE NO"
(Press key:0=NO,1=YES）
【*】
PC software
PLU records and setup data of the bPro can be programmed through a PC (Personal
Computer) using the METTLER TOLEDO program bSoft and bLabel New scales can
be easily set up by using this program.
Which requires an IBM or compatible PC with Windows 2000 or higher version
operating system. One serial port or Ethernet port is required. The wiring diagrams
shown in the following figure can be used to make cables from a 9-pin PC serial
port to the 9-pin connector at the bPro. Factory cables are available from METTLER
TOLEDO using the part numbers shown in the figure.
123848OTC Cable, PC DB9 to bPro 10ft/3m
bPro
DB9-F
TO 9-PIN SERIAL
RS232 PORT
PC
DB9-F
TO 9-PIN SERIAL
RS232 PORT
2
3
5
3
2
5