Instruction manual

59
Ticket print test
This function used to test the printer with ticket.

24【*】 Enter the preset code 24.
DISPLAY DESCRIPTION
RESIST 600-999 850 Select the Ohms Rating marked on the
Print Head.
SPEED 105 MM/S 0-5 Select the printer speed:
0=125mm/s; 1=115mm/s;
2=105mm/s; 3=95mm/s; 4=85mm/s;
5=75mm/s
ENERGY -4 -- +4 0 Enter print density (use CNT/WT CHANGE
key to input negative value)
PAP.END DET. NO 0-1 Enable paper end detecting (i.e. enable
the take label sensor)
0= disable; 1=enable
PRINTERTEST NO 0-1 Conduct printer test (To print out test
ticket)
0= No; 1=Yes
SENSORTEST NO 0-1 Conduct gap sensor test
0= No; 1=Yes
PAPER: ⇑ - ⇓
SENSOR OK OK=*
Slowly remove the ticket and insert the
ticket again in 10 seconds. The test result
will be shown.
Label Printer Test
This function is used to test label printer hardware and adjust printer
parameters.
25【*】 Enter the preset code 25.
DISPLAY DESCRIPTION
RESIST 600-999 850 Select the Ohms Rating marked on the
Print Head.
SPEED 85 MM/S 0-5 Select the printer speed:
0=125mm/s; 1=115mm/s;
2=105mm/s; 3=95mm/s; 4=85mm/s;
5=75mm/s
ENERGY -4 -- +4 0 Enter print density (use CNT/WT CHANGE
key to input negative value)
PAP.END DET. NO 0-1 Enable paper end detecting (i.e. enable
the take label sensor)
0= disable; 1=enable
REWIND NO 0-1 Enable rewind feature
0= disable; 1=enable
OFFSET 35 Enter offset length in mm (Eject distance)