Instruction manual

49
List CONFIG
Print out current keyboard config.
Operator configuration
Enter the menu【CODE】【4】【*】,display will show “OPERATOR CONFIG”, then do following
operation.
Standard configuration
【01】【*】 display “CONFIG. NO”
 press key 0＝NO，1＝YES，then press key 【*】. Press 【CODE】 to exit SETUP mode.
New configuration
【02】【*】 display “SERVICE MODE 0-1”
select the mode as power on: 0＝SERVICE MODE, 1＝PERPACK MODE, press key 【*】,
then display next option “DATE & TIME 0-2”;
 select print paper, 0＝TICKET, 1＝LABEL, 2＝LABEL+TOTAL LABEL , 3＝TOTAL LABEL ,
press key 【*】 , then display next option “DATE+TIME 0-2”;
select display contents as idle, 0＝RUNNING MESSAGE , 1＝DATE+TIME , 2＝BOTH OFF ,
then press key 【*】, display next option “SCREEN SAVER 0-5”;
select the idle time before displaying screen saver pictures: 0＝NO SCREEN SAVERS, 1＝
TWO MINUTES, 2=THREE MINUTES, 3=FOUR MINUTES, 4=FIVE MINUTES, 5=SIX
MINUTES, press key 【*】, then display next option “ONE SECOND 0-5”;
select the interval of screen saver pictures: 0＝ONE SECOND, 1＝TWO SECONDS,
2=THREE SECONDS, 3=FOUR SECONDS, 4=FIVE SECONDS, 5=SIX SECONDS, press key
【*】, then display next option “TARE DISPLAY 0-1”;
select if show and print tare, 0＝TARE DISPLAY , 1＝NO TARE , then press key 【*】,
display next option “PR. INPUT W/# 0-1”;
select inputting temporary price method with # key, 0＝PR. INPUT W/# , 1＝PR.INPUT
W/O # , then press key 【*】. Press key 【CODE】 to exit SETUP mode.
List Config
Print out the OPERATOR CONFIG