Instruction manual

12
recommended to provide protection from surges and spikes. The Power supply uses
an electronic overload protection circuit designed to protect the internal electrical
components.
Label Printer
Labels can be printed with the built-in thermal label printer. The printer uses a
60mm wide, high resolution, 8 dots/mm, thermal print head. The printer driver PCB
incorporates a heat detection circuit to ensure the best possible print quality while
eliminating any possibility of overheating the head. Overheating is the major cause
of premature print head failure. The print speed and density can be adjusted via
SERVICE MODE to compensate for varying types of labels.
The printer can use standard label sizes ranging from 25mm to 102mm long, and
continuous strip stock. Labels can be loaded in a stripped or un-stripped mode. In
stripped mode, the labels automatically peel from the backing liner. In the
un-stripped mode, the label and liner will be delivered. A tear/bar allows continuous
stock to be torn to exact length needed. Print specifications for the thermal printer are
as follows:
PRINTHEAD TYPE: Thick Film Thermal Printhead
DOT DENSITY: 8 Dots/mm
PRINT SPEED: 125 mm/sec maximum