Instruction manual

94
• Put the wireless kit (A1) to the position (G1).
• Install the bolts to it (H1).
• Take out the seal from hole (I1).
• Put the Ethernet harness through the hole (J1).
• Connect the Ethernet harness to the Ethernet port (K) and fix the harness as picture (L1).
• Put the wireless card power harness through the hole (M1).
• Connect the wireless card power harness to the main PCB (O1).
• Then to install the scale cover, the up spider, the main PCB cover in bottom, seal switch bolts etc.