Operator`s manual

Chain and Sprocket
Chain Tension
Check the tension of the chain , The Chain
slack should be
5 - 15mm (0.2 - 0.6in)
Chain tension (slack)
adjustment
1. Loosen the rear axle bolt
2. Adjust chain tension by turning the
chain tension nut. Clockwise will tighten
the chain. Counter clockwise will loosen
the chain.
3. Once the chain is at the correct tension
re-tighten Axle bolt (see torque spec chart)
4. Re-check chain tension.
Lubricating the Chain before each ride will
help to ensure maximum life of the Chain
and sprocket.
Instructions for cleaning and
chain lubrication
1. Clean chain with a chain cleaner
2. Lubricate chain with chain lube before
each ride.
Chain lubrication
MAINTENANCE
Rear Axle Bolt
Chain Tension Nut
Chain and sprocket inspection
Inspect the drive chain for wear, rust,
bound links, proper lubrication and proper
tension.
If the drive chain has a problem correct or
replace. Contact a service center for chain
replacement.
A worn drive chain could also mean the
sprockets may be worn.
Look for the following on the sprockets:
Worn teeth
Broken or damaged teeth
Loose sprocket mounting nuts.
If the sprocket shows signs of wear,
contact a service center for replacement.
Sprocket Wear Diagram
5 - 15mm (0.2 - 0.6in)
30