Operator`s manual

Idle speed adjustment
The idle speed should be set at 2000 ±
200 RPMs
To adjust the idle speed:
1. locate the idle adjustment (silver nger
knob) located on the Right hand side of
the vehicle just under the deck.
2. Allow the engine to warm up
approximately 10 minutes
3. With the engine running, turn the idle
adjustment knob in or out at small
increments until the correct idle is
achieved.
Note: A service center can perform this
adjustment . A diagnostic tachometer is
required for this adjustment.
Throttle Cable adjustment
The thumb throttle (2) should have 2.0 -
4.0mm (0.08 - 0.16) of free play.
Throttle cable adjustment:
1. Remove throttle lever housing top
cover (3 screws).
2. Loosen cable clamp screw (not shown).
3. Use pliers to pull cable tight and
simultaneously tighten cable clamp screw.
4. Check throttle lever action before
replacing housing top cover
Note: Make sure throttle snaps back to
idle when throttle lever is released.
MAINTENANCE
Throttle Lever housing screws
28