Operator`s manual

Engine Oil
The proper amount and grade of engine
oil will have a great impact on the life of
the engine. Check the oil daily. Changing
the engine oil as listed in the maintenance
schedule is the most important
maintenance procedure there is for the
engine.
Checking the engine oil
1. Make sure the DTV is on level ground.
2. Check engine oil level by looking at the
Dipstick . If oil is below the (L) level on the
Dipstick, add oil.
3. If engine oil is low (L), add oil until oil
is at the Full mark (H) on the Dipstick Use
the correct grade of oil as listed in this
manual. To avoid damage to the engine,
do not over or under ll with oil.
Changing the engine oil
1. Start engine and run for a short period
of time to allow the engine oil to warm up.
A warm engine will help oil drain quicker.
2. Remove front skid plate to gain access
to the oil drain plug.
3. Remove Oil Drain Plug.
4. Allow the oil to drain in an appropriate
container. Note: Dispose of oil at an oil
recycle center.
MAINTENANCE
Engine Oil ll plug
and Dipstick
Front Skid Plate screws
Engine Oil Drain
5. Install the drain plug and ll with the
appropriate type of oil as listed in this
manual. This DTV takes 600 ml (.63 qt) of
5w-30 full synthetic engine oil.
6. Re- install ll cap, Start engine and
allow to run for a few minutes, Re-check
oil level and ll accordingly.
27