Owner's Manual

6. Connection instructions
6- 3. Sensor part of VTLBSD1
L-Lamp
~
LED flasher ~
Blind Spot Detection Volume Adjustment Settings:
1: Mute
2: Low
3: Middle
4: High
LED flasher
Main unit
7. Troubleshooting
NO.
Issue Reason
Solution
1
LED flasher does
Wrong connection or pins
Check the harness and make
not work
not making contact sure connection is correct
LED flasher is broken Replace LED flasher
2 Opposite LED Microwave sensor or LED Make sure RED is driver side and
indicator flasher are plugged in to the YELLOW is passenger side.
opposite connector
3
Buzzer does not Wrong connection or pins not Check the harness and make
work making contact sure connection is correct
8. False Alarm
When engine is on , the system starts detecting the behind 01ects in the lanes next to the
driver. The detection range could be up to 80ft. Please note the system give warning
signal only when the behind objects are approaching.
False Alarms
Due to detection distance range, a vehicle travelling faster than your vehicle in the
blind spot detection area - two lanes away - may give false warnings as a vehicle
approaching toward your vehicle. Blind Spot Detection Volume Adjustment Settings
can be used to reduce beeper volume .