Installation Guide

Combo Shower Series
2
/
8
Screwdriver
Feature ：
This is a drill free sliding rack with suction cup. Product can be easily installed in a few easy
steps.
Installation Instructions:
⑴
1、Twine PTFE tape on the thread at the long end of elbow,
with a blind flange set in the elbow, and then spin the end of
elbow with PTFE tape to the outlet on the wall.
2. Put a gasket on the nut end of lifting lever, and then
tighten it on the elbow on the wall.
3.Tighten the hex nut by a wrench, so as to prevent water
leaking (wrap up the nut with a piece of cloth while
tightening in order to avoid nut scratched).
4. Detach the sucker from switching valve body, and select
A, B or C as required
A: In the vertical downward direction of the elbow, and at
the position of switching valve body against the wall, wipe
the wall cleanly, and then unscrew the sucker to compress
it tightly and evenly on the smooth wall, in order to
exhaust air.
B: In the vertical downward direction of the elbow, and at
the position of switching valve body against the wall, stick