Combo Shower Series SLF16002 2 Head Sliding Rail Shower Set Before Installing : Please check first if all accessories included in the package. Instruction includes information on proper installation and maintenance. Please read the instructions carefully before installing the products. Mounting particles are included for easy installation. Actual product might be slightly different in appearance, but same in structure. For better accuracy, please refer to the actual object.
Combo Shower Series Screwdriver Feature ： This is a drill free sliding rack with suction cup. steps. Product can be easily installed in a few easy Installation Instructions: ⑴ 1、Twine PTFE tape on the thread at the long end of elbow, with a blind flange set in the elbow, and then spin the end of elbow with PTFE tape to the outlet on the wall. 2. Put a gasket on the nut end of lifting lever, and then tighten it on the elbow on the wall. 4.
Combo Shower Series the double-sided tape on the wall evenly. C: In the vertical downward direction of the elbow, and at the position of switching valve body against the wall, lock the base on the wall with screws. 6. 5. Tighten the chassis free from falling off. Put a gasket into the ball head of top-spraying, and then tighten the top-spraying on the thread at the upper end of lifting lever.
Combo Shower Series 7. Put gaskets into the joints at both ends of hose, and then tighten the nut end on the lower thread of switching valve body. 9. Installation is finished. ⑵ 4/8 8.Tighten the sprinkler in hand on the speaker joint of hose, and then insert it on the slide bushing of lifting lever.
Combo Shower Series 1.Twine PTFE tape on the thread at the long end of elbow, with a blind flange set in the elbow, and then spin the end of elbow with PTFE tape to the outlet on the wall. 2.Put a gasket on the nut end of lifting lever, and then tighten it on the elbow on the wall. 4.
Combo Shower Series 6. Put a gasket into the ball head of top-spraying, and then 5.Tighten the chassis free from falling off. tighten the top-spraying on the thread at the upper end of lifting lever. 7.Put gaskets into the joints at both ends of hose, and then 8. Tighten the sprinkler in hand on the speaker joint of tighten the nut end on the lower thread of switching valve hose, and then insert it on the slide bushing of lifting lever. body.
Combo Shower Series 9.Installation is finished. Cleaning and Maintenance: - Many active ingredients in cleaning agents such as ammonia, detergent powder and toilet cleaners may destroy the coating of the product. and dry thoroughly with a soft cloth.
Combo Shower Series - Do not use abrasive cleaning materials on Lordear Products. - Pease follow the steps below if you experience dirt blocking the flow of the water after some time. a. Turn on the water and poke the holes with your fingers to gently to loosen minerals and release any remaining sediments. b. Turn off the water, remove the shower head and remove the mesh washer inside to clean with a small brush.
