Installation Guide

Shower Head Series
3 / 3
- According to picture, and place the rubber ring back in position.
Cleaning and Maintenance :
- Many active ingredients in cleaning agents such as ammonia, detergent
powder and toilet cleaners may destroy the coating of the product. For best
results, please use mild soap and dry thoroughly with a soft cloth.
- Do not use abrasive cleaning materials on Lordear Products.
- Please follow the steps below if you experience dirt blocking the flow of the
water after some time.
1. Turn on the water and poke the holes with your fingers to gently to loosen
minerals and release any remaining sediments.
2. Turn off the water, remove the shower head and the mesh washer inside to
clean with a small brush.
For questions regarding Sarlai Products, please contact:
- Technical support:
- Customer Service Representative:
- or visit