Installation Guide

Shower Head Series

1 / 3

Shower Head Series

Before Installation :

Please check first if all accessories included in the package.

Instruction includes information on proper installation and maintenance. Please

read the instructions carefully before installing the products.

Actual product might be slightly different in appearance, but same in structure.

For better accuracy, please refer to the actual object.

Inclusive Parts

Shower Head

Swing Arm

2 Washers

PAGE 1
Shower Head Series Shower Head Series Before Installation : Please check first if all accessories included in the package. Instruction includes information on proper installation and maintenance. Please read the instructions carefully before installing the products. Actual product might be slightly different in appearance, but same in structure. For better accuracy, please refer to the actual object.
PAGE 2
Shower Head Series Tools Needed for Installation: Cut off the Water Supply before installing. Wrap the Shower Arm with teflon tape on the thread before attaching to the side of the wall.Clockwise tighten shower arm. Wrap the Shower Arm with teflon tape on the thread, Tighten the shower head by rotating clockwise. To Finish the Installation Caution: - Remove the rubber ring before installing regulator.
PAGE 3
Shower Head Series - According to picture, and place the rubber ring back in position. Cleaning and Maintenance : - Many active ingredients in cleaning agents such as ammonia, detergent powder and toilet cleaners may destroy the coating of the product. For best results, please use mild soap and dry thoroughly with a soft cloth. - Do not use abrasive cleaning materials on Lordear Products. - Please follow the steps below if you experience dirt blocking the flow of the water after some time. 1.