Cust omer Service：3 2 3 -9 8 2 -8 9 5 5 Email：hd@boyelliving.com Websit e:w w w .boyelliving.
SKU(s): BL-A3 8 0 5 -BN Boyel Living Show er Set Inst allat ion TOOLS AND MATERIALS: BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing fixtures. We accept no liability for any damage to the plumbing, floor, walls, tub, or for personal injury during installation. Adjustable Wrench Phillips Screwdriver Drill Hex Wrench Soldering Kit (for copper pipe) ½" Test Plug Plumbers Tape Observe all local plumbing and building codes.
Boyel Living Show er Set Inst allat ion Step 1: Valve Installation 1. To prepare for installation, wood blocking should be installed between the two studs where the valve will mount. The face of the wood blocking should rest 1 ¼” behind the face of the wall studs. 3. Route, assemble, and connect all in-wall piping as desired to and from the shower valve. Make all connections appropriately depending upon the type of pipe that is being used.
Boyel Living Show er Set Inst allat ion Step 2: Trim Installation 4. Once all piping is routed and connections have been made, use the provided ½” test plug to perform a water pressure test. Turn on the main water supply to the home and water test the installed plumbing. Ensure that there are no leaks, then shut the water off. Remove the test plug. 1. Once the finished wall is complete, remove the protective sleeves from the valve stems. If the test plug has not yet been removed, remove that as well.
Boyel Living Show er Set Inst allat ion 3. Attach the 3-way diverter handle to the top stem by sliding it onto the spindle and tightening the set screw underneath, using the provided hex wrench. Repeat these steps to install the bottom single-function handle. 5. To install the hand shower’s water supply elbow, thread it onto the prepared 1/2” NPT pipe nipple. Apply thread sealant or plumber’s tape to the threads before tightening. Be sure to use the decorative escutcheon to conceal the rough-in. 4.
Boyel Living Show er Set Inst allat ion 7. Once the mounting brackets are attached to the wall, attach the slide bar by mounting it onto the brackets. To secure, tighten the set screws located on the slide bar using the provided hex wrench. 9. Install each of the body jets by threading them into the prepared female fittings. Be sure to use the decorative escutcheons to conceal the rough-ins. Apply thread sealant or plumber’s tape to the threads before tightening. 8.
Boyel Living Show er Set Inst allat ion 11. Complete the installation by attaching the shower heads to the installed shower arms. Apply thread sealant or plumber’s tape to the threads before tightening. 12. Turn the main water supply back on, and test the completed shower system. Ensure that there are no leaks and that all functions are working properly.
