Use and Care Manual
Table Of Contents
- CAUTIONS
- FEATURES
- PRODUCT DISCRIPTION
- DIGITIAL DISPLAY
- OPERATRIONS
- POWER/FUNCTION BUTTON
- UTurn the dehumidifier on
- Plug in the unit, the display screen flashes for one second, it buzzes and the screen shows ”- -”. Now the unit is on standby.
- ● Press POWER button, the dehumidifier turns on and enters AUTO mode.
- Lights up when in AUTO mode and the fan runs at high speed.
- ●Press the POWER button to switch between the following modes.
- Flashes for 3 seconds and lights up when press the power button again. The unit enters CONTINUOUS drying mode and the fan runs at high speed.
- Flashes for 3 seconds and lights up when press the power button again. The unit enters SLEEP mode and the fan runs at low speed.
- Modes toggling is as follows:
- UTurn the dehumidifier off
- Long press the POWER button for 3 seconds, the screen shows”- -”, the compressor stops immediately and the fan stops 30 seconds later.
- Modes Explanation
- AUTO MODE
- If ambient humidity ≦ 47%. Then the compressor stops, the fan stops 30 seconds later.
- If ambient humidity ≥53% fan running at high speed for 3 seconds, compressor start working.
- CNT/DRY CLOTHES MODE
- In CNT mode, the dehumidifier continuously runs at high fan speed until the ambient humidity reaches 20%. It is suitable for clothes drying or conditions that require continuous dehumidification.
- SLEEP MODE
- If ambient humidity ≦ 47%. Then the compressor stops, the fan stops 30 seconds later.
- If ambient humidity ≥ 53% fan running at low speed for 3 seconds, compressor start working.
- Water Tank Full Alarm
- UWater Tank Indicator
- ● When the tank is full for 5 seconds, it sets the alarm. The water tank indicator turns red and the unit buzzes for 15 times.
- UClear the alarm
- ● When the buzz is on, press the POWER button to stop it. The compressor, fan and ionizer generator shut down and all the functions freeze until the tank is emptied and back in right position.
- UEmpty the tank
- ● Grab the notch at the bottom of the tank and pull it out with both hands.
- Take it slowly and steadily in case of spilled water.
- ● Empty the water.
- ● Put the water tank back in position. The dehumidifier automatically starts working again.
- MAINTENANCE
- Always make sure the water tank is locked into place when putting it back, otherwise the dehumidifier cannot start up.
- Do not remove the float out of the tank otherwise the dehumidifier cannot start up.
- If the tank is dirty, wash it with cool/warm water. Do not use cleanser, steel balls, chemically treated dust-proof cloth, gasoline, benzene, thinners or other chemical solvents in case of damage and leakage.
- TROUBLE SHOOTING
