Installation Instructions

SERIES 5001
SLIDING GLASS DOOR
Page 9 of 19
Step 6. Setting the fixed panel (sealant is critical when setting this panel):
• Check the frame’s weather stripping, it should only be located where the fixed panel will
set (see Figure H).
• Be careful when sliding fixed panel into place (see Figure I).
• A critical seal is located at the meeting rail base and head (see Figure J).
FRAME WEATHER STRIPPING
@ FIXED PANEL SIDE
Figure H
HEAD
SLIDE
STRIPING
SILL
Seal to opening
JAMB
WEATHER
STRIPING
WEATHER
STRIPING
HEAD
SILL
JAMB
Seal to opening
Weather
Stripping
Weather
Stripping
Slide
Stripping
Figure I
FULL PERIMETER
SEALANT ON
FIXED SIDE ONLY
INSTALL AND BACK SEAL FIXED PANEL
INSERT ANGLE CLIPS, HEAD AND
SILL PRIOR TO INSTALLATION
Insert angle clips, head, and
sill prior to installation
Full perimeter sealant
on fixed side only
Install and backseal fixed
Figure J
CRITICAL SEAL
2" X 2" X 1/4" ANCHOR CLIP W/
(2) #10 X 3/4" PHL PH TEK SCREW
DEAD LOAD FASTENER
FIXED SASH
FRAME
CRITICAL SEAL
HEAD & SILL
2" X 2" X 1/4" ANCHOR CLIP W/
(2) #10 X 3/4" PHL PH TEK SCREW
Critical Seal
Dead Load Fastener
Fixed Sash
Frame
Critical Seal
Head and Sill
2" × 2" × ¼" Anchor Clip with
(2) #10 × ¾" PHL PH TEK Screw
2" × 2" × ¼" Anchor Clip with
(2) #10 × ¾" PHL PH TEK