Installation Instructions

SERIES 5001

SLIDING GLASS DOOR

Page 10 of 19

Step 7. Screw down the sill clip at the ﬁxed panel, maintaining the 2½" reveal (see Figures K & L).

Step 8. Screw the clip to the frame at the head, maintaining the 2½" reveal (see Figures K & L).

• The top clip has a deal-load fastener, and is different from the sill clip.

• Measure the jamb opening match center of the door opening dimension and run the

dead-load fastener screw into the meeting rail to plum the center opening dimension.

It may be necessary to remove shims and re-shim the head.

Step 9. Cap seal the ﬁxed panel:

Figure K

.25X2X2<

INSTALL PANEL CLIPS AND CAPSEAL PERIMETER OF FIXED PANEL

.375

DRILL #17 OR .173 DIA

PILOT HOLE AND INSTALL

DEAD LOAD FASTENER

AT HEAD

CAP SEAL FIXED PANEL

AFTER INSTALLATION

CAP SEAL FIXED PANEL

AFTER INSTALLATION

TOOL FOR WATER

SHED AT BASE

FIGURE H

Capseal ﬁxed panel

after installation

Drill #17 or .173 DIA pilot

hole and install dead load

fastener at head

Capseal ﬁxed panel after installation

tool for water shed at base

Install panel clips and capseal perimeter of ﬁxed panel

Figure L

.25X2X2<

FRAME WEATHER STRIPPING @ FIXED PANEL SIDE

FRAME WEATHER STRIPPING AT OPERABLE PANEL SIDE

.25X2X2<

FIGURE I

Frame weather stripping at operable panel side