Installation Instructions

SERIES 5001
SLIDING GLASS DOOR
Page 12 of 19
Step 11. Install the “X” (operable panel) threshold:
• Check the weather stripping on the interior side sill track. None should be in the way (see
Figure K).
• Back seal the center track across the panel and the jamb about 1
5
⁄
8
" up (see Figure M).
• Butter the ends and the sealant track on the threshold cover and snap into place (see
Figures O & P).
• Aesthetically clean excess sealant, as not to break any seals, and smooth any joints.
Figure 0
BUTTER EDGES WITH SEALANT
TYPICAL BOTH ENDS
THRESHOLD COVER
Q-LON WEATHER
STRIPPING
MARRY WEATHER STRIPPING
W/ SILICONE SEALANT
Q-LON WEATHER
STRIPPING
Butter edges with sealant
typical both ends
Threshold Cover
Q-Lon Weather Stripping
Q-Lon Weather Stripping
Marry weather stripping
with silicone sealant
Figure P
BUTTER EDGES W/ SEALANT
MARRY WEATHER STRIPPING
W/ SILICONE SEALANT
SNAP IN BAM-2040
FLUSH W/ SILL NOTCH
BAM-2040 SILL
ANTI TAKE OUT
TACK WITH SEALANT
TO PREVENT SLIDING
Butter edges with sealant
Marry weather stripping
with silicone sealant
Tack with sealant to
prevent sliding
BAM-2040 Sill
Anti Take-Out
Snap in BAM-2040
flush with sill notch