User`s manual

ManualsBrandsBOXLIGHT ManualsProjectorsProjector

BOXLIGHT PRO80S3 Projector Preliminary User’s Manual

Page 24 of 33

Non-Verbose Message Codes

Non-critical (Informational) Messages [M+ and V-]

%01$ LAMP Door Closed and Lamp TEMP OK

%02$ FANS OK

%03$ Film Projector ON – During Power-up

%04$ Film Projector OFF – During Power-up

%05$ Video Signal Detected – During Power-up

%06$ Striking Lamp – During Power-up

%07$ Restrike – Ballast RESET

%08$ Restrike – Lamp Restrike

%09$ Restrike – Restrike Fail

%0A$ Ballast COMM Failure – typically non-critical unless it least to !88$

Critical Messages / Shutdown Messages [V-]

!80$ Lamp Door Open or Lamp Overtemp – if after Power-up ► Shutdown

!81$ FAN Problem – if after Power-up ► Shutdown

!82$ NO Video – during or after Power-up

!83$ Video Signal Detected - Video Restored

!84$ Lamp Lit - During Power-up

!85$ Formatter COMM Disabled - Check SW500 – Power-up sequence halted

!86$ Restrike - Lamp Lit - After Power-up - 30 second Warm up before Shutter OPEN

!87$ Restrike Count Exceeded ► Shutdown

!88$ Ballast not Responding - After Power-up ► try Restrike

!89$ Ballast OVERTEMP ► Shutdown

!8A$ Lamp Extinguished - After Power-up ► try Restrike

!8B$ Resetting Formatters – usually non-critical

!8C$ LAMP SYNC Signal Inactive – usually non-critical

!8D$ LAMP SYNC Detected – usually non-critical

!8E$ Film Projector ON - After Power-up – Shutter CLOSED

!8F$ Film Projector OFF - After Power-up

!90$ RED FORMATTER Status Read Error – usually non-critical

!91$ GREEN FORMATTER Status Read Error – usually non-critical

!92$ BLUE FORMATTER Status Read Error – usually non-critical

!A0$ Power-up Sequence Complete – Ready for shutter OPEN

!E0$ Invalid Parameter in Command line

!E1$ Missing Parameter(s) in Command line

!E2$ Unknown Command

!F0$ Lamp Time Read from EEPROM – Lamp Hour EEPROM Read Error

!F1$ Strike Count Read from EEPROM – Lamp Hour EEPROM Read Error

!F2$ Power Off – MAIN Power OFF – System in Standby Mode

!F3$ 5 Minute Power Down Can celled by OPEN or ON Command

!F4$ 5 Minute Power Down Initiated – Lamp OFF and 60 second cool down in 5 minutes

!F5$ Powering Up – Main Power ON - Initiating Power-up Sequence

!F6$ Powering Down – Lamp OFF – 60 second cool down

Syntax: v+

VER VERSION VER

Display Controller Firmware Revision:

ver

* 720p MHF-69 Monitor – Rev. D03J

* 17 Nov 2006 *Syntax: ver