User`s manual

BOXLIGHT PRO80S3 Projector Preliminary User’s Manual

Page 20 of 33

Index Name Owner

0 Graphic Enhanced TI

1 NTSC TI

2 NTSC Enhanced TI

3 PAL SECAM TI

4 PAL SECAM Enhanced TI

5 EE Ambient Light Compensation #1 –

for low light level

6 EE Ambient Light Compensation #2 EE

7 EE Ambient Light Compensation #3 EE

8 EE Ambient Light Compensation #4 EE

9 EE Ambient Light Compensation #5 –

for medium light levels

10 EE Ambient Light Compensation #6 –

for medium light levels

11 EE Ambient Light Compensation #7 EE

12 EE Ambient Light Compensation #8 EE

13 EE Ambient Light Compensation #9 EE

14 EE Ambient Light Compensation #10 –

for high light levels

SETP LAMP POWER MODE SETP

GETP GETP

OSRAM Lamp support change lamp Output power. The output wattage of the lampdriver can be adjusted by command.

SETP is used to setup the lamp output wattage. For now, user can adjust 2 mode, 250W or 300W. And if system is

working in dual lamp mode, then it is set for dual lamp. It can’t separately set lamp setting. GETP is used to read lamp

output wattage. It can separately read the lamp setting.

Syntax: SETP {Power Mode} 0:250W ; 1:300W

GETP {Lamp Num} 1:Lamp1 ; 2: Lamp2

> setp 0

Set Lamp1 250W!

Set Lamp2 250W!

> getp 1

Lamp1 = 250W

IR+, IR- IR Remote Enable/Disable IR+, IR-

Enable (IR+) or disable (IR-) the infrared remote control interface. The IR remote POWER button is always

enabled. If the

projector is powered up using the IR remote, all other IR buttons are also enabled until an IR- command is issued or

POWER OFF.

Syntax: ir+

ir-

> ir+

IR Enable !!

> ir-

IR Disable !!