User`s manual

BOXLIGHT PRO80S3 Projector Preliminary User’s Manual
Page 2 of 33
1. Introduction
The Boxlight PRO80S3 Projector is a three-chip DLP projector with a native resolution of 1280x720 pixels (16:9 aspect
ratio). The projector accepts 720p video through a DVI-D connector on the rear panel.
1.1 Controllers
The projector is controlled by a pair of MTV312M64 microcomputers. The first is the main controller and is responsible for
lamp ballast and formatter initialization. It continuously monitors the state of the formatters, the ballast and the video input
primarily to prevent the lamp from extinguishing due to loss of video or unintentional resetting of the formatters due to
power fluctuations. Communication with the controller is through an RS-232 interface using a simple command/parameter
protocol. The second processor manages the IR remote control functions: lens shift, focus and zoom. It has no external
communications interface except the IR receiver.
1.2 Rear Panel Connectors, Switches and Displays
There are four I/O connectors, two switches and nine LEDs on the rear panel.
Rear Panel Connectors, Switches and Displays
Connectors
Connector/Switch/LED Purpose
DVI-D 720p Video Input. There is no scaler on board.
DB-9F Serial Communications with main µC – 9600,8,N,1
Film Projector Lockout Connector
RJ-45 NIC
Switch
2-position Rocker Switch Located just about the power connector – System Power ON/OFF
3-position Rocker Switch Soft Power ON/OFF and Shutter Control
LEDs
RED/GREEN LED Power State – located to the left of the Power/Shutter Control Switch
8 GREEN LEDs Projector Status – Located to the left of the DVI Connector
Multicolor LED
Power Sequence State
Color
State
RED
Standby
GREEN
Power On or Power-up Sequence
YELLOW
(GREEN + RED)
IF some STATUS LEDs ON – 5 minute power-down
ELSE power-off sequence
Status LED Operation
STATUS LED When ON Continuously When Flashing (or OFF)
LAMP DOOR
Lamp Door Interlock OK
Lamp Thermal Switch Closed
Lamp Door Open or
Lamp Thermal Switch Open - Shutdown
FAN Fans OK Fan Failure – Shutdown
LAMP
Lamp Struck and Operating Lamp Extinguished
Lamp Life time over system limited (1470 hours)
VIDEO SIGNAL Video Signal Detected No Video
FORMATTER
Formatters Initialized and Operating Formatter Failure (usually a communication failure) -
Shutdown
BALLAST TEMP Ballast Temperature OK Ballast Temperature High – Shutdown
READY
90 Second Lamp Cool-down Timer Expired, READY for
Power-up or Re-strike
[READY OFF] 90 Second Lamp Cool-down Cycle in
Progress
SHUTTER
Shutter OPEN
NORMAL Projection Mode
Shutter CLOSED
CURTAIN mode
NOTE: There may be as much as a 2 second delay between an event that will cause a change in the STATUS LEDs, e.g.,
SHUTTER OPEN, and the actual display update.