User`s guide

26
COMPUTER INPUT
MANUAL PC ADJUSTMENT
This projector can automatically tune to the display signals from most personal computers currently distributed. However,
some computers employ special signal formats which are different from the standard ones and may not be tuned by Multi-
Scan system of this projector. If this happens, the projector cannot reproduce a proper image, the image may be flickering,
non-synchronized, non-centered or skewed.
This projector has a Manual PC Adjustment to enable you to precisely adjust several parameters to match those special
signal formats. The projector has 5 independent memory areas to store the manually adjusted parameters. This enables you
to recall the setting for a specific computer whenever you use it.
Note : This PC ADJUST Menu cannot be operated when DVI is selected on PC SYSTEM MENU (P23).
Press MENU and ON-SCREEN MENU will appear. Press POINT
LEFT/RIGHT to move the red frame pointer to PC ADJUST.
1
2
Press POINT DOWN to move the red frame pointer to the item
that you want to adjust and then press SELECT. Adjustment
dialog box will appear. Press POINT LEFT/RIGHT to adjust
value.
Move red frame icon to the item and press
SELECT.
PC ADJUST MENU
PC ADJUST Menu icon
Adjusts image as necessary to eliminate flicker from the display.
Press POINT LEFT/RIGHT to adjust value. (From 0 to 31.)
Fine sync
The number of total dots in one horizontal period. Press POINT
LEFT/RIGHT and adjust number to match your PC output.
Total dots
Adjusts horizontal picture position. Press POINT LEFT/RIGHT to
adjust the position.
Horizontal
Adjusts vertical picture position. Press POINT LEFT/RIGHT to adjust
the position.
Vertical
Press SELECT to show the information of computer selected.
Current mode
Adjusts clamp level. When the image has a dark bar(s), try this
adjustment.
Clamp
Press SELECT at this icon to adjust
“Clamp,” “Display area (H/V)” or set
“Full screen.”
Press POINT LEFT/RIGHT
to adjust the value.
Shows status
(Stored / Free) of the
selected Mode.
Selected Mode
Press SELECT at Current
mode icon to show the
information of computer
connected.
Current mode
Downloaded From projector-manual.com Boxlight Manuals