User`s guide

22
COMPUTER INPUT
SELECTING INPUT SOURCE
MENU OPERATION
DIRECT OPERATION
Select INPUT source by pressing INPUT button on Top Control.
Select INPUT source by pressing COMPUTER 1 or COMPUTER 2
on Remote Control.
If projector cannot reproduce proper image, select correct input source
through MENU OPERATION (see below).
Press MENU and ON-SCREEN MENU will appear. Press POINT
LEFT/RIGHT to move the red frame pointer to INPUT.
Press POINT DOWN to move the red arrow pointer to Computer
2 and then press SELECT. Source Select Menu will appear.
1
2
INPUT button
Computer 1
Video
Move pointer (red arrow) to
Computer 1 and press
SELECT.
Computer 1
Move pointer to RGB
and press SELECT.
Source Select Menu
INPUT MENU
INPUT Menu icon
Move pointer to either RGB (Digital) or RGB (Analog) and then
press SELECT.
3
When digital signal is connected to DVI terminal,
select Digital.
RGB (Digital)
When analog signal is connected to DVI terminal,
select Analog.
RGB (Analog)
Computer 2
Press MENU and the ON-SCREEN MENU appears. Press
POINT LEFT/RIGHT to move the red frame pointer to INPUT.
Press POINT DOWN to move the red arrow pointer to Computer
1 and then press SELECT. Source Select Menu will appear.
1
2
Press POINT DOWN and a red-arrow icon will appear. Move
arrow to "RGB" and press SELECT.
3
Computer 2
Move pointer to RGB
(Digital) or RGB (Analog)
and press SELECT.
Source Select Menu
INPUT MENU
When the digital or analog output from a computer is
connected to the Computer 2 (DVI-I) terminal on the
projector.
When the analog output from a computer is connected to
the Computer 1 (HDB 15-pin) terminal on the projector.
INPUT Menu icon
Move pointer (red arrow) to
Computer 2 and press
SELECT.
When computer is connected to Computer 1, select
RGB.
RGB
When video equipment is connected to Computer 1
terminal, select RGB (Scart). Refer to P31.
RGB (Scart)
Downloaded From projector-manual.com Boxlight Manuals