Instruction manual
Table Of Contents
- Heading1 - Table of Contents
- Heading1 - Safety Instructions
- Heading1 - Introduction
- Heading1 - Setting up the Projector
- Heading2 - Connecting the CablePro™III to the Projector
- Heading2 - Preparing to Connect Your Equipment to the Projector
- Heading2 - Connecting a Laptop Computer
- Heading2 - Connecting a Desktop Computer
- Heading2 - Connecting a Computer Using a VESA cable
- Heading2 - Connecting a Video Player
- Heading2 - Connecting an External Speaker
- Heading2 - Powering up the Projector and Adjusting the Image
- Heading2 - Turning Off the Projector
- Heading1 - Using the Projector
- Heading2 - Basic Image Adjustment
- Heading2 - Using the Remote Control
- Heading2 - Adjusting the Projector
- Heading2 - Using the Remote and Keypad Buttons
- Heading2 - Using the On-Screen Menus
- Heading2 - Display Menu Functions
- Heading2 - Audio Menu Functions
- Heading2 - Image Menu Functions
- Heading2 - Controls Menu Functions
- Heading2 - Language menu
- Heading2 - Status menu
- Heading1 - Maintenance & Troubleshooting
- Heading1 - Appendix
- Heading1 - Index
40
Maintenance & Troubleshooting
CAUTION: Never operate the
projector with the lamp cover open
or removed. This disrupts the air
flow and causes the projector to
overheat.
5
Loosen the two non-removable screws on the outside of the
module (Figure 30).
6
Remove the module (Figure 30).
FIGURE 30
Removing the lamp module
WARNING: Do not drop the
lamp module or touch the glass
bulb! The glass may shatter and
cause injury.
7
Align the new lamp module in the correct direction.
8
Gently push the module in as far as it goes.
9
Tighten the screws on the outside of the module.
10
Reposition the lamp cover.
11
Tighten the lamp door screw.
12
Plug in the power cord and turn the projector back on. The
lamp monitor light and lamp hour counter in the Status menu
are automatically reset.
Downloaded From projector-manual.com Boxlight Manuals