Instruction manual
Table Of Contents
- Heading1 - Table of Contents
- Heading1 - Safety Instructions
- Heading1 - Introduction
- Heading1 - Setting up the Projector
- Heading2 - Connecting the CablePro™III to the Projector
- Heading2 - Preparing to Connect Your Equipment to the Projector
- Heading2 - Connecting a Laptop Computer
- Heading2 - Connecting a Desktop Computer
- Heading2 - Connecting a Computer Using a VESA cable
- Heading2 - Connecting a Video Player
- Heading2 - Connecting an External Speaker
- Heading2 - Powering up the Projector and Adjusting the Image
- Heading2 - Turning Off the Projector
- Heading1 - Using the Projector
- Heading2 - Basic Image Adjustment
- Heading2 - Using the Remote Control
- Heading2 - Adjusting the Projector
- Heading2 - Using the Remote and Keypad Buttons
- Heading2 - Using the On-Screen Menus
- Heading2 - Display Menu Functions
- Heading2 - Audio Menu Functions
- Heading2 - Image Menu Functions
- Heading2 - Controls Menu Functions
- Heading2 - Language menu
- Heading2 - Status menu
- Heading1 - Maintenance & Troubleshooting
- Heading1 - Appendix
- Heading1 - Index
10
Setting up the Projector
Connecting a Desktop Computer
1
Locate the cable that connects your monitor to your computer.
Unplug it from the computer.
2
Plug the end of the CablePro cable into the monitor con-
nector on your computer.
FIGURE 8
Connecting the CablePro cable to an IBM-compatible desktop computer
Do you want to display the image on your computer’s monitor as well
as on the projection screen?
NOTE: The projector must be
turned on to display the image on
your monitor.
1
Plug your monitor’s cable into the connector on the
CablePro.
Do you want to play your computer’s audio on the projector?
1
Unplug the audio cable, if present, from your computer.
2
Plug either end of the CablePro audio cable into the audio
connector on your computer.
3
Plug the other end of the audio cable into the connector
on the CablePro.
Downloaded From projector-manual.com Boxlight Manuals