Instruction manual
Table Of Contents
- Heading1 - Table of Contents
- Heading1 - Safety Instructions
- Heading1 - Introduction
- Heading1 - Setting up the Projector
- Heading2 - Connecting the CablePro™III to the Projector
- Heading2 - Preparing to Connect Your Equipment to the Projector
- Heading2 - Connecting a Laptop Computer
- Heading2 - Connecting a Desktop Computer
- Heading2 - Connecting a Computer Using a VESA cable
- Heading2 - Connecting a Video Player
- Heading2 - Connecting an External Speaker
- Heading2 - Powering up the Projector and Adjusting the Image
- Heading2 - Turning Off the Projector
- Heading1 - Using the Projector
- Heading2 - Basic Image Adjustment
- Heading2 - Using the Remote Control
- Heading2 - Adjusting the Projector
- Heading2 - Using the Remote and Keypad Buttons
- Heading2 - Using the On-Screen Menus
- Heading2 - Display Menu Functions
- Heading2 - Audio Menu Functions
- Heading2 - Image Menu Functions
- Heading2 - Controls Menu Functions
- Heading2 - Language menu
- Heading2 - Status menu
- Heading1 - Maintenance & Troubleshooting
- Heading1 - Appendix
- Heading1 - Index
9
FIGURE 7
Connecting the CablePro audio and mouse cables to a laptop computer
If your computer has a USB connector and is running Windows 98,
use the USB cable
NOTE: The USB mouse is sup-
ported for use with Windows 98
only.
1
Plug the end of the CablePro mouse cable into the
mouse connector on your computer.
2
Plug the end of the CablePro mouse cable into the
connector on the CablePro.
You must have the appropriate USB drivers installed on you
computer to use the USB feature. Windows 98 ships with the
appropriate drivers.
NOTE: A USB mouse is hot-plug-
gable, meaning you do not need to
re-boot your computer after con-
necting the mouse to use it. A PS-2
mouse is not hot-pluggable.
Now you’re ready to power up the projector and your laptop.
Skip to “Powering up the Projector and Adjusting the Image” on
page 15.
audio cable
mouse cable
Downloaded From projector-manual.com Boxlight Manuals