Owner`s manual

27
One Way Bearing Inspection and Adjustment
For proper operation of the Treadles, the One Way Bearings must be in the operational (green) zone. If a Treadle is
lifted or moved incorrectly before the Dependency is connected, the One Way Bearings can roll out of the operational
zone disabling the Treadles.
To correct either of the One Way Bearings, you will need to disconnect the Dependency from the Treadle Assembly. Be
sure to place the Treadle Support Block under the Treadles before you disconnect the Dependency (for reference, see
assembly steps 2 and 3).
With the Treadle Support Block supporting the Treadles, use a 16 mm wrench and 5 mm hex head wrench to remove
the hardware. Standing at the front of the machine, slightly lift and hold the Treadles and push the Walking Belts.
Continue this operation until both of the One Way Bearings are to the back of the machine. Lower the Treadles onto the
Treadle Support Block.
Do not wear loose clothing or jewelry. This machine contains moving parts. Do not put fingers or other objects
into moving parts of the exercise equipment.
The Walking Belts can abruptly move. To avoid possible serious injury, keep hands away from the edges of the
Walking Belts.
When the One Way Bearings are in the operation zone, reconnect the hardware. Be sure not to lift the Treadles too high
when re-attaching the Dependency or the bearings may need to be adjusted again.
Maintenance