Owner`s manual

20
Pausing or Stopping a Workout
To pause a workout, stop walking and bring the Speed value to 0. The workout will pause after 2.5 seconds. Push the
SCAN button to cycle through the workout values. When a workout is paused, the workout icons do not fl ash.
Note: If a paused workout is not restarted in 5.5 minutes, the machine will shut off.
To restart your workout, simply start walking again. To end a workout, push and hold the START/STOP button for 3
seconds.
Console Service / Setup Mode
From the Power Up/Idle Mode, push and hold the START/STOP and SCAN buttons for 3 seconds to access the Console
Service/Setup Mode.
Display Option Description
UnIt Units Select your preferred unit of measurement; “Lb” = English
Imperial, “SI” = metric
StAt Statistics Displays the total time, calories, and distance the
machine has been used since it was activated or the last
reset.
Note: Push and hold the SCAN button to reset and erase
the statistics.
COdE Firmware Version Displays the fi rmware version
bAtt Battery Voltage Displays the percent of battery power remaining
EdgE Speed Detection Select between modes; “0” = 1 point, “1”= 2 points
Push the SCAN button to cycle through the Options, and push START/STOP to select the Option.
Use the SCAN button to view the details of the Option, and push the START/STOP button to confi rm your selection. For
options without details to cycle through, push the START/STOP button to exit the option.
To exit the Console Service/Setup Mode, push and hold the START/STOP button for 3 seconds.
Note: The fitness machine can not be immediately shut off from the Console Setup Mode. The user must exit
Console Setup Mode, and then push and hold START/STOP for 3 seconds.
Operations