Owner`s manual

6. Wait until the belts dry fully (approximately 2-4 hours).

7. Using a 5 mm hex wrench, tighten the tension adjustment bolts for the walking belts. Turn the bolts clockwise to

increase the tension.

8. Plug in the machine and turn on the power.

9. Inspect the walking belt alignment and tension before using the machine. Refer to the walking belt alignment and

belt tension adjustment procedures.

Note: Repeat the procedure to apply anti-static spray if static electric discharge occurs again. The machine

will accumulate more static electric charge when the surrounding air is drier. Be sure to obey the

manufacturer safety instructions for the anti-static product.

Maintenance