Service manual

Accessing the LED Board

Tools Needed:

• Phillips Screwdriver

• 1/2 inch wrench

NOTE: If using a powered driver, it must be on the “LOW

TORQUE” setting, otherwise it will strip screws.

Step 1 Unplug machine from wall outlet.

Step 2 Wait 5-minutes after unplugging machine to

ensure there is no residual power.

Step 3 Remove right rear base decal. See Figures 1.

Step 4 Remove right rear base plastic cover (3 screws).

See Figure 2 and 3.

Step 5 Refer to the LED Diagnostic chart on the

following pages to diagnosis LED lights.

TC5300/TC6000 DIAGNOSTICS

Figure 1:

Figure 2:

Figure 3:

AS LONG AS THE TREADCLIMBER® FITNESS

MACHINE IS PLUGGED INTO A POWERED OUTLET

AND THE POWER SWITCH IS ON, THE UNIT IS

RECEIVING POWER, EVEN IF THE DISPLAY IS

TURNED OFF. ALWAYS UNPLUG THE POWER CORD

FROM THE OUTLET AND WAIT 5-MINUTES BEFORE

PERFORMING REPAIRS OR MAINTENANCE.

7 ! 2 . ) . '

! 4 4 % . 4 ) / .

$ ! . ' % 2

)--%$)!4%!#4)/.2%15)2%$

# ! 5 4 ) / .