Owner`s manual
38
Condition/Problem Things to Check Solution
Unit will not power up/turn on/start Outlet Make sure outlet is functioning correctly. Verify
this by plugging another device (ex: lamp) into
the outlet. If outlet is connected to a light switch,
check to make sure it is on. If outlet is not
functioning fi nd a working outlet.
Power cord not plugged
in
Make sure the power cord is fi rmly secured to
A/C inlet on the unit and fi rmly inserted into a
non-GFI wall socket.
Power switch turned off Make sure the power switch at the rear of the
unit is in the “ON” position. Switch will light up
red to indicate power is present.
Safety key not plugged
in
Plug Safety Key into Console (See Safety Key
(Emergency Stop Procedures) within Features
section).
Speed displayed is not accurate Display set to wrong unit
of measure. (English/
Metric)
Change display units.
Walking belt misalignment Rear belt guides Belts should ride on top of triangular black belt
guides at rear of treadles.
Tracking adjustment Belts are not required to be perfectly centered
and are typically farther out in the rear than
they are in the front. This may vary depending
on user’s stride. If belt is tracking to one side
far enough to cause rubbing of belt, consult the
“Adjusting the Walking Belts” procedure.
Speed dependent grinding or
scraping noise
Belt alignment Check walking belt alignment. Belt contact with
metal guides under Treadle can make a loud
grinding sound. If belts are misaligned, adjust
walking belt.
Rollers or motor Contact Customer Care for further assistance.
Hesitation or belt slipping when
walking on unit
Walking belt tension Adjust walking belt tension by following the
“Adjusting the Walking Belt” procedure.
Knocking noises when unit is
operating
Igus bushing If knocking sound seems to be coming directly
from the rear roller, check Igus (yellow “hat”
shaped) bushings and replace if cracked.
Hydraulic cylinder bolts Check and tighten both upper and lower bolts
that connect the hydraulic cylinders to the unit.
Troubleshooting