Owner`s manual

this procedure to apply an anti-static spray to them to reduce the static electric charges.

Wait a minimum of 60 minutes after the last workout before you apply the anti-static spray, to let hot

electrical components cool to room temperature.

1. Unplug the machine from the wall.

To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug

the power cord from the wall outlet and/or the machine and wait 5 minutes before cleaning, maintaining or

repairing the machine. Place the power cord in a secure location.

2. Using a 5 mm hex wrench, loosen the tension adjustment bolts for the walking belts to let them slide easily.

Turn the bolts counterclockwise to decrease the tension.

Note: Be sure to record how many turns it takes to loosen the bolts to assist with reassembly.

3. Carefully apply the anti-static spray to lightly cover the top surface of the walking belts along the front of the

machine, farthest from the motor (green highlighted area).

NOTICE: Hold the spray dispenser approximately 6” (13

cm) above the walking belt and point the spray toward the

front of the machine, away from the motor. Apply the spray

only on the belts, not on the deck or mechanism. If spray

goes off the belts, wipe the excess spray off the other parts

of the machine.

Note: Be sure to obey the manufacturer safety

instructions for the anti-static product.

4. Using your foot, manually advance the walking belts

toward the back of the machine, exposing the next

unsprayed section.

5. Do steps 3 and 4 again until all sections of the belts are

lightly coated with anti-static spray.

6. Wait until the belts dry fully (approximately 2-4 hours).

7. Using a 5 mm hex wrench, tighten the tension adjustment bolts for the walking belts. Turn the bolts clockwise to

Maintenance