Owner`s manual

START ACTION
START
FINISH
START ACTION
START
FINISH
Bowflex Xtreme
®
2 SE Owner’s Manual
43
Triceps Pushdown – with Bent Lat Bar (Elbow Extension)
Muscles worked:
Triceps
Position:
Standing – facing machine
Accessory:
50” Bent Lat Bar
Pulleys:
Lat Tower
Before You Begin:
Remove Leg Extension and Seat
Key Points:
Keep upper arms motionless.
Keep wrists straight.
Tighten triceps throughout exercise
and control motion on the way up.
Maintain good posture by keeping
chest lifted, abs tight. Maintain a very
slight arch in lower back.
START
FINISH
Stand on platform.
Grasp 50” Bent Lat Bar at
shoulder width, palms down.
Bring arms down to sides,
elbows straight. This is Start
Position.
Bend over from hips, so shoul-
ders are over hands. Lift chest
and tighten abs to stabilize
spine while maintaining a
slight arch in lower back.
Keep upper arms stationary
and elbows next to sides of
torso. Slowly allow elbows to
bend, moving hands in arcing
motion away from legs and up.
Stop at 90º.
Think about tightening triceps.
Slowly reverse arcing motion
and straighten arms fully.
START
FINISH
Arm Exercises
Single Arm Pushdown—Elbow Extension
Grasp one Hand Grip, palm
facing downward.
Stand approximately 1-2 feet
from Lat Tower (adjust for
comfort), but keeping feet on
Standing Platform.
Bring your arm in front of
you, Hand Grip at chest level.
Bend over slightly from
hips, so that your shoulder is
directly over your hand.
Keeping your upper arm
stationary, elbow next to
trunk, slowly push your arm
downward in a gentle arc until
your hand is near top of the
thigh.
Keeping your triceps
tightened, slowly reverse the
arcing motion, bringing the
Hand Grip back to the start
position.
Muscles worked:
Triceps
Position:
Standing—facing machine
Accessory:
Hand Grips
Pulleys:
Lat Cross Bars
Leg Extension:
Removed
Success Tips
Keep your upper arms motionless and
your wrists straight.
Keep your chest lifted and maintain
spinal alignment, keeping a very
slight arch in your lower back.
Tighten the triceps throughout the
exercise, using controlled motion.
Keep your knees bent and feet on
Standing Platform.