Owner's Manual

Bowflex Xtreme
®
2 SE Assembly Manual
17
Assembly Guide
Step 18 Cable and Pulley Routing – Connect Pulleys and Cables to the Lat Pulley
Housing
Locate the following items for the Lat Pulley Housing assembly:
• (2) Pulleys from step 17
• 3/8” X 4 1/2” Hex Head Bolt – uninstalled in Step 17
• 3/8” Washer – uninstalled in Step 17
Note: Connecting the Cables is much easier with a second persn assisting you.
18-1 Holding both Cables from Step 17 in place, align the 2 Lat Pulleys as shown in Figure 18. Slide the Pulleys
back into the Lat Pulley Housing, lining up the bolt holes in the Pulleys and Lat Pulley Housing.
18-2 Place the Washer over the 4 1/2” Bolt from Step 17. Slide the Bolt through the aligned holes in the Lat Pulley
Housing and Lat Pulleys as shown in Figure 18.
Tighten all hardware.
Note: You will probably need to push the Power Rod
®
unit out of the way for this step. The Power Rod
®
unit is
not pictured for the sake of clarity.
2
2
1
1