Owner's Manual

Bowflex Xtreme
®
2 SE Assembly Manual
5
Assembly Guide
Step 2 Install Lower Lat Tower Assembly
Parts:
• Lower Lat Tower Assembly
• Base Frame Assembly (1)
Hardware:
• 2 Hex Head Bolts 3/8” X 3 1/4” (R)
• 4 Flat Washers 3/8” (B)
• 2 Nylock Nuts 3/8” (O)
Tool: 7/32” Hex Wrench
2-1 Align the Lower Lat Tower Assembly
over the Base Frame.
2-2 Secure Lower Lat Tower Assembly
using screws and washers as shown.
Finger tighten screws at this time.
Step 1 Install Power Rod
®
Pack to Lower Lat Tower Assembly
Parts:
• Lower Lat Tower (3)
• Rod Box with Power Rod
®
Pack (2)
Hardware:
• 3 Phillips Screws #10 X 1” (F)
• 3 Flat Washers 1/4”(A)
Tool: Phillips Screw Driver
1-1
Lay parts on floor as shown. Firmly slide
Rod Box into Lower Lat Tower frame.
1-2 Fasten the Rod Box to the
Lower Lat Tower frame as shown.
Tighten screws until snug.
3
2
F
A
?
R
B
1
B
O