Service manual

Common Service Procedures
Calibration
Calibrate the Treadmill after replacing a component, like
a belt or motor, and after a power outage. Calibrating
the Treadmill is an important part of troubleshooting and
maintenance.
Do not stand on the walking belt during the entire
calibration process. Stand on the side foot support
platforms or rubber mat only.
1. Plug power cord into wall outlet and turn on power
switch.
2. Stand on the side foot support platforms or rubber
floor mat. DO NOT STAND ON THE WALKING
BELTS.
3. Insert the Safety Key.
Note: The Bowflex
®
Treadmill does not power up
if the Safety Key is not fully inserted into the safety
keyhole.
4. Press and hold hold “ENTER” and “POWER” for 3
seconds while the Console is dormant. The word
“CAL” shows on the display.
5. Press “START”. This enables display of maximum
speed (with unit of measure) and maximum incline.
6. Verify correct units of measure (English imperial/
metric). Press “START” to change from one type
to another. Press “ENTER” one time to set the
measurement unit.
7. Press “START”.
8. Press “POWER” again to save and exit, once
calibration is complete.
Service Manual
7