Service manual

Replacing Parts

18. Reverse the operation to install the replacement

belt and assemble the treadmill.

Note: When you install the roller bolts into the front

and rear roller axles (see Steps 7 and 5), it may

be easier if you use a tool to align the bolt holes

on one side (Figure 11) while you install the

other side.

Note: When you put the rear roller back on the frame

(reverse of Steps 6 and 5), it may be necessary

to use a lever against the frame to install the

roller (Figure 12) due to the tightness of the new

walking belt.

Note: When you tighten the motor tension bolt (see

Step 3), adjust the tension until you can push

down the top surface of the motor drive belt

approximately 0.25” (0.64 cm).

19. Spray silicon lubricant between the new walking

belt and the deck.

Walking Belt Replacement (cont.)

Figure 12

Figure 11 – Align bolt holes (rear axle shown)

Service Manual