Service manual
Troubleshooting Procedures
3. Press the enter key once. After a slight delay, a
beep sounds and “CAL” appears in the upper right
window.
4. Press the start key. The system enters the auto
calibration mode.
5. Press the start/stop key to pause auto calibration.
6. Press the enter key to manually toggle through
the calibration points while and save your current
values. Press the scan keys to toggle through
without saving. The order is: MIN PWM, ½ PWM,
MAX PWM, ELEVATION UPPER LIMIT, ELEVATION
LOWER LIMIT.
On the belt calibration screens, the actual speed shows
in the upper left window, the current PWM shows
in the upper right window and the target calibration
speed shows in the lower right window.
On the elevation calibration screens, the input volts
shows in the upper left, the a/d ticks shows in the
upper right and the mode shows in the lower right.
HARDWARE TEST
1. Enter engineering mode.
2. Press start once. Max speed and units shows (“E”=
ENGLISH, “n”= METRIC).
3. Press the enter key once. After a slight delay, a
beep sounds and “CAL” appears in the upper right
window.
4. Use the up/down keys to scroll until “tESt” shows in
the upper right window.
5. Press the start key.
The elevation keys directly control the elevation, the
speed keys directly control the belt PWM, and the scan
keys manually ramp up and down the fan PWM. The
fan keys are also enabled.
DISPLAYS
• UpperLeft=ActualHR
• UpperRight=ActualSpeed
• LowerLeft=ElevationA/Dcounts
• LowerRight=BeltPWM
Service Manual
11