Service manual

Troubleshooting Procedures

No Power to the Unit

1. Check power to the outlet.

2. Check plug at unit and AC inlet receptacle for

damage

3. Check circuit breaker (red pin by on/off switch). If it

is tripped, it will be popped out and you will need to

click it back in. If it is not tripped, it will not move.

4. Remove the motor cover to see if any LED light are

lit on the lower control board.

5. Use a multi-meter to verify if voltage is getting past

the circuit breaker, if you do not see any LED lights

lit on the power supply. Replace the circuit breaker

if no voltage shows.

6. If the LED lights are on (indicating current past

the circuit breaker) then check if the safety key is

functioning by removing and replacing it. When this

is done you should get a beep and the software

version shows on the Display.

7. If the LED lights are on and the safety key is not

functioning (and no power to upper board), use a

multi-meter to test if DC voltage goes to the upper

electronics. On a unit with the telco style cables,

you should check the 8 PIN cable on the #2 and #5

pins, getting a reading between 2 and 12 DC volts.

If it is the I/O cables with the white ends, it would

be the #4 PIN (yellow wire) and #6 PIN (blue wire).

If you are not getting any reading, then check the

connections and replace if necessary.

8. Replace the limit switch if there is no reading and

the safety key does not respond.

9. Replace the upper electronics if you have checked

all the above and they are functioning properly and

you still have no power.

Plug the treadmill into its dedicated outlet. If possible, use

a surge protector. Treadmill does not operate correctly on a

GFI basement or garage outlet.

General Power Source and Electrical Plug Set Up

Service Manual