Manual

750 50 0002 03
40
17 Appendix
17.1 List of symbols
Surface measurements Two-coordinate measuring mode
Diameter measurements Transposition of the coordinate system
Centerline distance measurements Alignment/rotation of the coordinate system
Minimum value of the measured surface
(MIN)
Calculation of the pitch circle diameter (PCD)
Maximum value of the measured surface
(MAX)
Cartesian coordinate system
Difference between maximum and minimum
values (DELTA)
Polar coordinate system
Display of ambient temperature Back to the original coordinate system
In-line help Creation of a reference center point
Advanced functions Checking of the alignment of center points
Probe constant Distance between 2 center points
Squareness
Angle between 1 center point, the origin and
the X axes
Inclination
Angle between 2 center points and the X
axes
Rectilinearity Angle between 3 center points
Angle Table of the original measured values
Lock-in of a selected measuring unit (mm or
inch)
Table of the calculated values
Height of the setting gauge
Transfer of the calculated values to the
buffer
Height of the parallel gauge block for
checking angles
Closing of the 2D mode
Date Buffer
Time Management of the buffer contents
Contrast / luminous power Saving of a buffer contents
Adjustment of the air cushion displacement Recalling of a buffer contents file
Standby mode Deleting of a memory file (buffer contents)
Switch off mode
Memory status
ON/OFF key