Manual

750 50 0002 03
20
Performance of a two-coordinate measurement
1. Numbering of all bores to be checked
2. Determination of the rotation angle
3. Starting of the 2D session
4. Performing of all measurements in Y axes
5. Rotation of the component
6. Performing of all measurements in X axes (same sequence than for Y axes)
7. Evaluation of all requested results
7.1.2 Start
After numbering of all bores (shafts), determine the rotation
angle and pick up the required references.
Select the 2D mode by pressing the advanced function
symbol and then the 2D symbol. A window, asking for
confirmation, will be opened.
The start of the 2D mode will now be confirmed in the buffer
by the text START 2D.
7.1.3 Acquisition of centerline distances
Acquisition in Y
Perform all centerline measurements according to the
diameter/centerline mode (§5.3). The number of the bore
(shaft) to be checked is indicated below the current
measurement value. 99 bores (shafts) can be acquired.
Change of the number of the centerline axes
If the number of a bore (shaft) is not convenient, it can be
changed. Press the Functions key and enter the required
number. Confirm by pressing Enter.
1, 2, 3 …
Clear a last measurement
It is possible to clear a last measurement by pressing Clear.
Rotation of the part
All measurements in Y axes performed, press the Enter key.
A default rotation angle of 90° will be suggested. It is possible
to enter any other value between 45° to 135°. Confirm the
rotation by pressing Enter.
1, 2, 3 …